20
Awning
Fence
3°~4°
Over
50 cm
75~150 cm
Note: Unit may be supported
by a solid frame from below
or by a hanger from a solid
overhead support.
installation instructions
Note:
Before installing, remove all packaging from inside the car-
ton, along with any inserts placed into the side louvers.
suggested tools
• Screwdriver (medium size Phillips).
• Tape measure or ruler.
• Knife or scissors.
• Level.
select the best location
1. To avoid vibration and noise, make sure the unit is installed se-
curely and firmly.
2. Install the unit where the sunlight does not shine directly on the
unit. If the unit receives direct sunlight, build an awning to shade
the cabinet.
3. There should be no obstacle, such as a fence or wall, within 50 cm
from the back of the cabinet because it will prevent heat radia-
tion of the condenser. Restriction of outside air will greatly reduce
the cooling and heating efficiency of the air conditioner.
4. Install the unit a little obliquely outward not to leak the con-
densed water into the room (about 3~4 with level).
5. Install the unit with its bottom portion 75 ~ 150 cm above the
floor level.
6. The power cord must be connected to an independent circuit. The
yellow/green wire must be grounded.