37
IN THE EVENT OF A POWER OUTAGE, YOU CAN LIGHT SUR-
FACE BURNERS BY APPROACHING A LIT MATCH TO THE
BURNER, THEN CAREFULLY TURN THE KNOB TO THE “HIGH/ ”
SETTING. BE CAREFUL WHEN TURNING ON THE BURNERS THIS
WAY.
BURNERS THAT WERE LIT AT THE MOMENT OF THE POWER
OUTAGE WILL STAY OPERATING NORMALLY UNTIL THEY ARE
TURNED OFF.
Built-in electronic ignition
(Applies to models EM1770, EM1771 and JEM1770)
Just make sure to plug the power cord into a properly grounded receptacle.
1
Push the knob in and turn it counterclockwise to the setting marked with the icon or
"HIGH" setting.
2
You will hear the characteristic sound of the burner’s electric ignitor.
3
Once the burner is lit, turn the knob so you can adjust the flame to the desired size.
When operating the knob, all ignitors will spark, this is normal. This sound is normal and is
caused by the air-gas mixture inside the burner.
HIGH
LOW
Match ignition ranges
(Applies to models L1700, L1700T, 1700T, J1700T, JL1700T, PREM700, JEM1748, DL1750T,
EM800 and EM1700)
1
Make sure control knobs are in the OFF position.
2
Light a match.
3
Push and turn the knob that controls the burner you want to use towards the HIGH po-
sition.
4
Carefully approach the lighted match to the burner.
Button electronic ignition ranges
(Applies to models JEM1758, EM17655 and EM1758)
When pushing the button or turning the knob, ignitors will automatically spark
on all burners. This is normal.
1
Make sure knobs are in the off position, if equipped with mechanism knobs, they should
be in the “out” position. Make sure range is plugged in to electric power.
2
Press and hold the electronic ignition button, marked
with a thunder icon, you will hear the characteristic
sound of the burner’s electric ignitor.
3
Press the knob that corresponds to the burner you want
to use and turn it to HIGH setting, the burner will light
within few seconds. Once lit, release the button and
regulate the flame size turning the knob.
