MAAX xstream, Руководство пользователя

Страница: 24 / 46

23
23
Swim Spa
User’s Pads
User’s Pads are the buttons located on the
topside control panel and are used to program
various spa functions (i.e., turn on spa light, set
temperature, etc.). The following table defi nes
the buttons:
Pad Use
Temp
• Decrease temperature
• Increase temperature
• Switch modes
• Change fi ler cycle durations
Light
• Turn internal spa light on or off
• Switch modes
Jets
• Activate therapy pump
• Set duration of fi lter cycles
Temperature
The maximum set temperature is 104°F
(40°C) and the minimum set temperature is
80°F (26°C). The current water temperature
or, if the pump has not been running, two
dashes, will show on the display. If dashes are
displayed, you must fi rst start the pump by
pressing the
PUMP 1 pad. Wait until the water
temperature is displayed (approximately 2
minutes).
The set temperature of your spa may easily
be increased or decreased at any time using
the ‘
TEMP’ pad. Press the ‘ TEMP’ pad; the
set temperature will be displayed in the
LCD window. The next touch of ‘
TEMP’ will
change the set temperature either up or
down 1°F (0,5°C). If you want to increase
the temperature and the displayed indicates
the temperature was increased by 1°F (0,5°C),
continue to press the
TEMP pad until the
desired set temperature is reached.
If you want to decrease the set temperature
and the LCD indicates that the temperature is
increasing,
STOP . Wait a few seconds until the
actual temperature is displayed. Then press
the
TEMP pad again. The set temperature
will be displayed. Press it again and the set
temperature will decrease by 1°F (0,5°C).
Continue pressing the
TEMP pad until the
desired set temperature is reached.
If the spa is set in Standard mode or in a
fi ltration cycle, increasing the set temperature
may result in activating the heater. Decreasing
the set temperature will turn the heater off .
When the heater is operating, the LED below
the
HEAT icon will be lit.
Pump 1
Touch the JETS 1 pad to activate the primary
fi ltration pump. The sequence of the jet action is:
1 touch = Low therapy jets
2 touches = High therapy jets
3 touches = Off
The low speed operation of Pump 1 is timed
to automatically turn off after two hours of
operation. The high speed operation of Pump
1 is timed to automatically turn off after 30
minutes of operation.
NOTE: With the standard confi guration,
pump 1 will automatically operate in
low speed whenever the spa calls for a
fi ltration cycle or heat. When this automatic
activation occurs, the low speed of Pump