MAAX xstream, Руководство пользователя

Страница: 21 / 46

20
20
Swim Spa
button to advance the hours up or down to
the desired set point. Press the
PROG button to enter the time hour. The
minute digits will now be fl ashing on the
LCD window. Press the
UP or DOWN button
to advance the minutes up or down to the
desired set point. Press the
PROG button to
enter the time minutes. At this point you can
either proceed with setting the fi ltration cycles
as described in the following ‘Changing Filter
Cycle’ section, or press the
TIME button to
save the settings and exit the programming
sequence.
Preset Filter Cycles
Once the time of day has been set, your Swim
Spa will automatically fi lter the water for a
2-hour period every 12 hours.
The fi rst fi lter cycle comes preset to operate
from
8:00AM to 10:00AM , and the second
fi lter cycle comes preset to operate from
8:00PM to 10:00PM . The F1 indicator light
will be lit whenever the Swim Spa is in the
fi rst fi lter cycle. The F2 indicator light will be
lit whenever the Swim Spa is in the second
fi lter cycle. During a fi lter cycle, the primary
fi ltration pump will operate in low speed and
can not be turned off unless the Swim Spa is
put into the Standby mode. At the beginning
of each fi ltration cycle, the other equipment
in the Swim Spa will turn on for 30 seconds to
purge all plumbing lines and ensure complete
fi ltration.
Changing Filter Cycles
The control system allows you to adjust the
start time and duration of each fi lter cycle
independently to best suit your schedule. The
amount of time needed to fi lter your Swim
Spa will vary depending upon usage and
ambient conditions, but a total fi lter time of
pressing the PROG button.
Sleep Mode heats the Swim Spa to within
20°F (11°C) of the set temperature only
during fi lter cycles. The
‘SLEEP’ icon will be
displayed in the LCD window when this mode
is selected.
Changing Modes
To change the operating mode, press the
PROG button. The operating mode will be
fl ashing on the LCD window. Press the DOWN
button to cycle through to the desired mode,
and then press the
PROG button to confi rm
selection. Pressing UP or DOWN then JETS2
will put the Swim Spa into the Standby Mode .
While in this mode, all Swim Spa functions
are temporarily suspended to allow for fi lter
changes or other routine maintenance tasks.
Press any button to exit the Standby mode.
Note: Always put your Swim Spa into
Standby Mode whenever cleaning or
changing your fi lters.
Time and Filtration Cycles
The control system on your Swim Spa has
been designed to function properly and safely
at 100°F (38°C) after connecting the electrical
wires and installing the proper grounds. To
take full advantage of the unique capabilities
of your new Swim Spa, you should fi rst set the
time and establish your fi ltration cycles.
Setting the Time
When the time of day has not been
programmed, the ‘
TIME’ icon will be fl ashing
on the LCD window. To set the time of day,
fi rst press the
TIME button then press the
PROG button. The hour digit(s) will be fl ashing
on the LCD window. Press the UP or DOWN