MAAX xstream, Руководство пользователя

Страница: 22 / 46

21
21
Swim Spa
will revert back to display the current water
temperature.
Pressing the TIME button at any time during
the above programming sequence will save
the values entered up to that point and exit
the programming sequence.
To set the Swim Spa for continuous fi ltration,
set the start and end times of the fi rst fi lter
cycle to the exact same time.
Clean-Up Cycle
After periods of heavy use, you can manually
start a cleanup cycle by turning
JETS 1 on in
low speed. The pump will operate for 2 hours
and then automatically turn off . The heater will
also operate during this period if the controls
are set in the Standard mode.
NOTE: Activating the low speed of
Pump 1 for a clean up cycle will initiate
fi ltration, but not ozone production, unless
the Swim Spa enters a timed fi lter cycle
during the 2 hour period.
Inversion Feature
The Swim Spa Series Control includes an
Inversion feature that makes it easy to read the
LCD from inside or outside the Swim Spa. To
invert the LCD display, you will need to locate the
general location to the right of the
LIGHT button.
First touch the UP or DOWN button, followed by
the position located next to the LIGHT button.
Repeat the sequence to reverse the inversion
process.
at least four hours per day is recommended to
properly clean and maintain the water.
To initiate the programming sequence to
change fi lter cycles, press
TIME, PROG, PROG,
and PROG within 3 seconds. You should now
see the ‘ PROGRAM’, ‘FILTER 1’, and ‘ START
TIME’ icons on the LCD display window.
The hour digit(s) will be fl ashing on the LCD
window. Press the
UP or DOWN button to
advance the hours up or down to choose the
Filter 1 start hour. Enter the hour by pressing
the
PROG button. The minute digits will now
be fl ashing on the LCD window. Press the UP
or DOWN button to advance the minutes up
or down, in 5 minute increments, to choose
the Filter 1 start time. Enter the minutes by
pressing the
PROG button.
You should now see the ‘ PROGRAM’, ‘FILTER 1’,
and ‘ END TIME’ icons on the LCD display
window. Adjust the hours and minutes for the
end time of the fi rst fi lter cycle as described
above. After pressing the
PROG button to
enter the end time of the fi rst fi lter cycle, you
should now see the ‘
PROGRAM’, ‘FILTER 2’,
and ‘ START TIME’ icons on the LCD display
window. Adjust the hours and minutes for
the start time of the second fi lter cycle as
described above.
After pressing the PROG button to enter the
start time of the second fi lter cycle, you should
now see the ‘
PROGRAM’, ‘FILTER 2’
and ‘ END TIME’ icons on the LCD display
window. Adjust the hours and minutes for
the start time of the second fi lter cycle as
described above. After pressing the
PROG
button to enter the end time of the second
fi lter cycle, the new fi ltration times will be
saved into the system and the LCD window