E
n
g
lis
h
F
ra
n
ça
is
20
MAAX SPAS PERFORMANCE SERIES
comes preset to operate from 8:00AM to
10:00AM, and the second filter cycle comes
preset to operate from 8:00PM to 10:00PM.
The F1 indicator light will be lit whenever the
spa is in the first filter cycle. The F2 indicator
light will be lit whenever the spa is in the
second filter cycle. During a filter cycle, the
primary filtration pump will operate in low
speed and can not be turned off unless the
spa is put into the Standby mode. At the
beginning of each filtration cycle, the other
equipment in the spa will turn on for 30 sec-
onds to purge all plumbing lines and ensure
complete filtration.
Changing Filter Cycles
The control system allows you to adjust the
start time and duration of each filter cycle
independently to best suit your schedule.
The amount of time needed to filter your spa
will vary depending upon usage and ambient
conditions, but a total filter time of at least
four hours per day is recommended to
properly clean and maintain the water.
If you are setting the filter cycles as a continu-
ance from setting the time then proceed to
the next paragraph. To initiate the program-
ming sequence to change the filter cycles,
press ‘ Time’, ‘Mode/Prog’, ‘Mode/Prog’, and
‘Mode/Prog’ within 3 seconds.
You should now see the ‘PROGRAM’, ‘FILTER 1’,
and ‘START TIME’ icons on the LCD display
window. The hour digit(s) will be flashing on
the LCD window. Press the ‘Warm’ or ‘Cool’
button to advance the hours up or down to
choose the Filter 1 start hour. Enter the hour
by pressing the ‘Mode/Prog’ button. The
minute digits will now be flashing on the LCD
window. Press the ‘Warm’ or ‘Cool’ button to
advance the minutes up or down, in 5 minute
increments, to choose the Filter 1 start time.
Enter the minutes by pressing the ‘Mode/
Prog’ button.
You should now see the ‘PROGRAM’, ‘FILTER 1’,
and ‘END TIME’ icons on the LCD display
window. Adjust the hours and minutes for
the end time of the first filter cycle as
described above.
After pressing the ‘Mode/Prog’ button to
enter the end time of the first filter cycle, you
should now see the ‘PROGRAM’, ‘FILTER 2’,
and ‘START TIME’ icons on the LCD display
window. Adjust the hours and minutes for
the start time of the second filter cycle as
described above.
After pressing the ‘Mode/Prog’ button to
enter the start time of the second filter cycle,
you should now see the ‘PROGRAM’, ‘FILTER 2’,
and ‘END TIME’ icons on the LCD display
window. Adjust the hours and minutes for
the start time of the second filter cycle as
described above.
After pressing the ‘Mode/Prog’ button to
enter the end time of the second filter cycle,
the new filtration times will be saved into the
system and the LCD window will revert back
to display the current water temperature.
Pressing the ‘Time’ button at any time during
the above programming sequence will save
the values entered up to that point and exit
the programming sequence.
To set the spa for continuous filtration,
set the start and end times of the first filter
cycle to the exact same time.
Clean Up Cycle
After periods of heavy use, you can manually
start a clean-up cycle by turning Pump 1 on in
low speed. The pump will operate for 2 hours
and then automatically turn off. The heater
will also operate during this period if the
controls are set in the Standard mode.
Inversion Feature
