9
Hakki Pilke 38 Easy
Original
Version 6
2.4.
Preparing the machine for operation
Note! The pushbar lugs may be installed either way depending on the size of the tractor.
3.
Control functions and preparation
3.1.
Arranging the machine for operation and transport
Before arranging the machine for transport, ensure that the operating conditions detailed in Section 1.4 are
met and review the safety instructions in Section 1.5.
Note! Inspect and clean the machine according to Sections 4.3 and 5.8 before arranging it for transport.
3.1.1.
Placing the input conveyor in the operating or transport position
Place the input conveyor in the operating
position as follows:
1.
Ensure that sufficient room is
available to lower the input
conveyor (approx. 2 m).
2.
Release the lock by lifting handle A
upward with your left hand.
Note!
At the same time, hold the end of
the input conveyor with your right
hand!
3.
Lower the input conveyor down
with your right hand and, at the
same time, use your left hand to
guide the support leg C into slots B,
as instructed in Figure 4.
When placing the input conveyor in the
transport position, lift the conveyor up
and ensure that the locking latch locks it in
place, as instructed in Figure 3.
Figure 3.
Figure 4.
