16
www.massportal.com
Perimeters
: printing speed for normal perimeters – usually about 50–100 mm/s;
Small perimeters
: If the radius is <=6.5 mm, decrease the
Perimeters
speed usually to 50-80%;
External perimeters
: printing speed for outer perimeter, recommended as above - 50-80% from
Perimeters
;
Infill
: how fast to print the infill. Can be set to 60-120 mm/s as it mostly won’t be visible;
Solid infill
: Printing speed for solid layers should be less and therefore more accurate. Recommended
50-80% from
Infill
;
Top solid infill
: same as the previous setting, but for the top layer. Also should be 50-80% from
Infill
;
Support material
: recommended 30-60 mm/s for the support material printing;
Bridges
: recommended 30-60 mm/s for the bridge printing;
Gap fill
: smaller gaps should be filled a bit slower – 20-40 mm/s;
Travel
: traveling speed of the printer head, 200-400 mm/s is recommended;
First layer speed
: print the first layer at about 30-40% of the general speed to get better adhesion to the
printing surface.
NOTE!
By using too fast printing speeds the quality of printed 3D objects may decrease significantly. Please use
the recommended values or lower ones to get better printing results
