Lightcommander
Lightcommander
Lightcommander
Lightcommander
Lightcommander 111112/2
2/2
2/2
2/2
2/2
eMail: [email protected] . Tel.: + 49 9 31 49 79 40 . User's Manual Lightcommander 12/2
11
11
11
11
11
Dipless Crossfade (Insert Mode)
Memory X-Fade by using Flash buttons:
•
Switch off
Channel Flash
, to release the flash buttons.
•
Set up
Chaser Master
and select
Insert
within the Chaser section.
(If a Chaser is running, it stops at the actual step))
•
Use the
X-Fader
to set the required
Fade time
.
Press
a
Memory flash button.
Î
The memory fades in at the set time.
Each other selected Memory will initiate a Crossfade from one into
the next Memory, in order of selection.
Î
Use the
Step button
, to achieve a fade between the actual
and the previous Memory.
Î
Switching
Insert OFF
, causes the Chaser to
continue
.
Note:
Chaser Master
sets maximum
output level
of Insert Steps.
Manual Memory Crossfade:
•
Turn on
Insert
and
Manual
.
•
Move the
X-Fader
from end to end. After fading in a memory
(i.e. fader full up or full down), select the next to be faded.
•
If you don't select a Memory, the previous one is faded in and you
can change between both. The Chaser Master controls brightness.
Fading out Memories:
•
Turn
Insert
off and press the
Step button,
or use the
X-Fader
to fade down.
(This depends on the kind of Insert mode, you have selected).
•
Note: If a Chaser was preselected, a Step will be faded in.
Inserting Preset A
Î
Use the
Master-A
-
Flash button
to insert the actual scene from
Preset-A
-.
Previewing and Editing a Memory
Previewing a Memory store before setting up the cue
•
Turn
Preview
on and select a Memory with the Flash buttons.
Î
The Memory store is indicated on the LED´s.
Preview automatically turns Live mode
off
(if selected).
The consoles output will not be affected.
Editing a Memory store
Î
While
previewing, select
Modify
out of the displayed menu.
•
Use the
Channel fader
to "grab" the preprogrammed level.
Î
Modify as required and save using
Quit
. Ready!
The output will not be affected by this.
Programming Memories blind
•
Turn Live off if it is selected, using the Shift+Live buttons.
•
Set
Master-A-
to zero and program as usual.
Î
The setting on Preset A will not affect the output.
NOTE:
When the desk is switched to
LIVE
while editing a Memory
this Memory appears at the output.
Preview
Memory
+
Содержание Lightcommander 12/2
Страница 1: ...Lightcommander 12 2 User s Manual Version 1 32 June 15 1995...
Страница 36: ......
