M7 AG5085, Руководство пользователя

Страница: 19 / 24

7
2) OFF:
①
Side Switch:: Press the rear of the
switch (10), the switch will automatically
flop to position “0”;
②
Rear Switch: Shift
rear switch (9) to “0”.
3) Moving the parts after starting power tool.
4) Once the safety brush torn, grinder is
designed to be turned off automatically.
Avoid the motor was damaged.
6. TURNING GEAR BOX
1) Take off four bolts connecting gear box and
housing.
2) Turn the gear box to left 90 or right 90 in the
gear case wasn’t unsheathe condition.(NOTE:
If the distance between gear box and housing is
more than 2mm, have repaired at your nearest
Authorized Service Center).
3) Reassembly the four bolts
，
after and screws
tight guarantees the bolt not slippery tooth.
APPLICATION
WARNING : To reduce the risk of injury,
electric shock and damage to the tool, before any
work check the utility lines electricity, gas or water
supply line are hidden in the work area.
WARNING
: Firmly grasp primary hold part of
tool and side handle before starting.
1. GRINDING APPLICATION
1) When grinding, keep a 15
°
angle between the
wheel and the work piece, the best grinding
results can be achieved with part contact.
2) For avoid the work piece will not overly heat up
nor discolor and no ridges will be formed, move
the machine back and forth with moderate
pressure.
3)
Never use cut-off wheel to grind work
piece.
4) Always hold the tool properly so that sparks
and grinding dust fly away from the body.
WARNING: Sparks generated when
grinding metal. Take care that no
combustible material presented in the area
of flying sparks.
TOOL MAINTENANCE
WARNING: Before any work on the
machine itself, pull the power plug.
1. Avoid the tool vibration or impact, and keep it
from oil and grease.
2. Inspect bolts periodically. If the bolts loosen,
tighten them immediately, or will result in
serious accident.
3. Inspect tool cords periodically. If
damaged, have repaired at your nearest
Authorized Service Center.
4. Keep the rents clean. Clean all parts of the
tool, clean dust periodically. To prevent debris
entry.
5. Change the brush. Inspect and change the
brush by Authorized Service Center to
ensure safety operation and long use life.
6. All service MUST only be performed by
Authorized Service Center. ALWAYS use
only accessories that are recommended for this
tool.
7. Cleanliness. Avoid the use of plastic cracks
caused by damage to the solvent. Use clean
cloths and mild soap to clean the plastic housing.