Industrial BOX-HMI Hardware Manual
M2I Corporation
11-35, Simin-daero 327beon-gil, Dongan-gu, Anyang-si, Gyeonggi-do 14055, Korea, Tel: +82-70-465-3366, Fax: +82-31-465-3355, www.m2i.co.kr
15 / 16
8.3 Problems with the Device
(1) If there is a problem during operation, stop using it and contact the A/S department of M2I Corporation,
which is indicated on the product label.
(2) Only the authorized worker from M2I Corporation can check and repair problems related to malfunction of
the machine.
(3) If the problem cannot be solved at the installation site, the equipment can be collected and moved to M2I
Corporation.
(4) The manufacturer, M2I Corporation, is not responsible for damage or malfunction of the equipment caused
by the use conditions of the user beyond the installation and use standards described in the manual.
(5) When electromagnetic noise is over-radiated, Install the ferrite core to the body power and field power lines.
Depending on the installation environment, noise from power lines and communication lines may be high.
(6) In noisy places, recommended use of industrial display devices.
(7) If the HDMI and USB devices do not operate normally due to noise, install ferrite cores on both ends of the
cable to improve noise tolerance.
8.4 Setting System Recovery Mode
(1) If the system fails to boot normally due to a problem during operation, the built-in recovery function can be
used to maintain the factory default state. Please note that the built-in project will be deleted when using the
recovery mode.
(2) By the mode switch on side, you can adjust the setting switch. Keep the "Normal" state when booting
normally. If the system is recovering, turn off the power and set it to "Factory Reset".
(3) When the recovery is completed, the buzzer sounds, then turn off the power and reset to "Normal" state.
