location for the outside edge of the element clamp on the REAR DRIVEN ELEMENT assembly with a marking
pen or pencil. Install the REAR DRIVEN ELEMENT as you did for the REFLECTOR Make sure you follow the
element placement on the DIMENSION SHEET. Continue installing the rest of the elements in the same
fashion. After all of the elements have been installed take a couple of steps back and look down from the end of
the antenna. Check to see if the elements are lined up with one another. If any need to be fixed, simply loosen
the saddles, straighten, and re-tighten.
10. INSTALLATION OF PHASING LINES ( see figure 7)
Locate the two 3/8” tube phasing lines, the phasing line insulator, and one cable tie. Insert both tubes into the
two holes on the insulator. Temporarily loosen the 1/4-20 locknuts located on the FRONT and REAR DRIVEN
KT34M2 ASSEMBLY MANUAL
Содержание KT34M2
