4. How to use
To use temp. controller
1-1.Connect the sesor on No.17 terminal of the rear side(Use external sesor)
1-2.If sensor is connected on No.17 terminal on the rear side, take it out and use internal sensor.
2.Connect No. 15 of the rear side with an electric outlet and switch on the instrument by No.14 of the rear side..
3.Press No. 8 key of the front side, then the parameter to set temperature will be appeared.
To use Timer
1.Press No.8 key on the front side for 2seconds, then the parameter to set temperature will be appeared.
Minimum 1 minute(0001) to Maximum 99hr59min.(9959)
2.After setting of time, press No. 8 key on the front side, then it return to the initia condition.
3.Press No.10 key on the front side for 2 seconds on timer run, then No. 6 lamp will be switched on and off.
In case that time is not setted, it does not run.
4.Press No. 10 key for 2seconds on timer run, then it stop to run..
5.Press No. 9 key for 2 seconds, then the temperature display shows the remaining time.
Press No. 9 key again for 2 seconds, then the temperature display shows setting value.
1.Use without auto-tuning but do it in case of a big temperature difference.
2.Press No.11 key, then it starts with switching on and off.
3.Temperature error could be happened on auto-tuning but it is controlled correctly when auto-tuning is finished..
4.Temperature go higher than the setting value first time but it is returned to normal condition immediately.
(Over-shoot condition)
5.In case that temperature goes down, it is differ as per the charater of the liquid and the ambient condition.
6.Be careful so that the contents are overflowed from the vessel. It makes the malfunction and damage
of the instrument.
7.In case that the replacement of the sensor or the switch of internal and external sensor are needed,
switch off the power and make it. If it is made under power ON, it cause a wrong operation.
tlm
Set the time using No. 9 and 10 key.
30
0
6.In case that the set of time is finished, "tENd" is showed and press No.10key to back to the initial condition.
Su
Press No.9 (downturn) and No.10 (upward) to set the required temperature.
30
4. After setting of the temeprature, press No.8 key on the front side for 2 seconds, then the temperature controller
runs on initial condition.
Su
Prees No. 8 key again.
1
2
8
13
6
9
1
1
5
15
1
16.Sensor S/W
12
14
Front Panel
Rear Panel
