R3S-YV4
5-2-55, Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN
Phone: +81(6)6659-8201 Fax: +81(6)6659-8510 E-mail: [email protected]
EM-8940 Rev.1 P. 4 / 4
WIRING INSTRUCTIONS
■
APPLICABLE WIRE SIZE
•
Solid
: 0.2 to 1.0 mm
2
(0.55 to 1.12 dia.)
•
Stranded
: 0.2 to 1.5 mm
2
(Tinning wire ends may cause contact failure and therefore
is not recommended.)
• Ferruled:
Unsheathed: 0.25 to 1.5 mm
2
Sheathed: 0.25 to 0.75 mm
2
• Expose wire conductors by 10 mm (0.39”).
Stripped length
10mm
■
CONNECTION PROCEDURE
Insert the wire end until it comes to a full stop while push-
ing slot with the tip of a screw driver as shown below. Be
sure wire insulation is not inside the terminal.
Screw Driver
Power wire
OUTPUT PIN ASSIGNMENT
PIN No.
FUNCTION
1
VH1
2
COM1
3
VL1
4
SLD
5
VH2
6
COM2
7
VL2
8
SLD
9
NC
10
NC
11
VH3
12
COM3
13
VL3
14
SLD
15
VH4
16
COM4
17
VL4
18
SLD
19
SLD
20
SLD
FUNCTIONS
■
OUTPUT HOLD or OUTPUT OFF
In normal conditions, the module outputs the signal from
the preferred bus A.
When an error is detected, the output is switched to the
data from the bus B.
• Output Hold
If both are in error, the module holds the signal and stands
by until one of the communications recovers.
• Output OFF
If both are in error, the module outputs -15 % (or approx.
-11.5 V) and stands by until one of the communications re-
covers.
At the startup, it outputs -15 % (or approx. -11.5 V) until the
communication is established and normal data is received.
