M2EXV
5-2-55, Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN
Phone: +81(6)6659-8201 Fax:
+81(6)6659-8510 E-mail: [email protected]
EM-5133-B Rev1 P. 14 / 18
[90] Display setting
Set display setting in measuring mode. Display is di-
vided, indicating item can be set for each upper and lower.
Pressing Set button once is setting for upper, pressing again
for lower, pressing once more for setting determined.
Upper
SETTING VALUE
DESCRIPTION
INITIAL VALUE
INPUT
Input engineering unit value
INPUT
(engineering
value)
INPUT (Scaling)
*1
Input scaling
PERCENT
Percent value
*3
OUTPUT
Output engineering unit value
OUTPUT (Scaling)
*2
Output scaling
*1. Display at measuring mode is INP (Scaling).
*2. Display at measuring mode is OUT (Scaling).
*3. Input percent value.
Lower
SETTING VALUE
DESCRIPTION
INITIAL VALUE
INPUT
Input engineering unit value
PERCENT
(percent value)
*3
INPUT (Scaling)
*1
Input scaling
PERCENT
Percent value
*3
OUTPUT
Output engineering unit value
OUTPUT (Scaling)
*2
Output scaling
None
No display
*1. Display at measuring mode is INP (Scaling).
*2. Display at measuring mode is OUT (Scaling).
*3. Input percent value.
[91] Brightness
Adjust brightness of display. It is available to set the range
between 1 (darkest) – 4 (brightest).
Initial value: 4
[92] Display timeout
Set the time to off the display when there is no operation
within a certain time.
It is available to set the range between 0 – 60 minutes.
Set ‘0’ to display ‘always on’.
When error is occured at display off, the display returns
from off.
Initial value: 10
[93] Reset all settings
Return settings to initial value.
SETTING VALUE
DESCRIPTION
OFF
Not initialized.
RESET
Initialize all settings.
*1
*1. When setting value is initialized, each parameters cur-
rently set are over written by initial value. ‘COMPLETE’ is
indicated when initializing setting value is completed. No-
tice that it does not return to the setting value, which is
specified by the option Ex-factory setting (/SET). Configure
initialized value again with DIP switch with power off for
output setting.
[94] Version indication
Indicate firmware version.
[01] Lockout Setting
Set Lock / Unlock of lockout setting.
SETTING VALUE DESCRIPTION
INITIAL VALUE
Lock
Lockout setting enable
Lock
Unlock
Lockout setting disable
Even when setting is ‘Lock’, it is available to move on to
each setting mode and confirm the setting value of each
setting parameter. In each setting parameter display, when
‘Lock’, ‘DATA (Locked)’ is indicated, when ‘Unlock’, ‘DATA’
is indicated.
