65
73VR2102 / 73VR2104 / 73VR2106 / 73VR2108 / 73VR2110 / 73VR2112 USERS MANUAL EM-7395-B Rev.24
7.3 SETTING COMMENTS
1. Touch Page button at the bottom of the Group setting view. Turn pages until the screen shows the comment entry
view you want to set up.
2. Touch the comment field and enter a comment. Character size is automatically adjusted according to the number
of characters and character width (e.g. smaller size when ‘w’ or ‘m’ are used than when ‘ t ’ or ‘ i ’ are.)
3. Enable ‘Auto Write In’ if needed. More explanations are give in the following.
4. Touch Page button to go to another comment entry.
Auto write in
Comments can be automatically written on the chart according to preset conditions. Choose Enable to use this function.
Discrete/Analog
Specify the signal type (analog or discrete) that you want to use to trigger the automatic comment entry.
Threshold
Specify the threshold value for analog trigger signal.
Threshold
Max. 6 digits including a decimal point and minus sign
Condition
For analog trigger signal, the following conditions can be used to trigger the comment entry.
Value > Threshold
The comment is written in when the subject pen signal goes above the analog trigger signal
value.
Value < Threshold
The comment is written in when the subject pen signal goes below the analog trigger signal
value.
Value ≥ Threshold
The comment is written in when the subject pen signal is equal to or goes above the analog
trigger signal value.
Value ≤ Threshold
The comment is written in when the subject pen signal is equal to or goes below the analog
trigger signal value.
For discrete trigger signal, the following conditions can be used to trigger the comment entry.
Up
The comment is written in when the subject pen signal turns from OFF to ON.
Down
The comment is written in when the subject pen signal turns from ON to OFF.
Pen number
Choose the pen number for the trigger signal.
