M Solutions MS-070RI, Руководство пользователя

Страница: 6 / 9

06
support@m4sol.com
| www.m4sol.com
MS-070RI USER GUIDE
Power
The MS-070RI uses individual power supplies to provide power the Transmitter and Receiver.
Please only use the supplied 5V/2A DC PSU’s supplied with the MSolutions MS-070RI units to
power.
IR Control
The MS-070RI can distribute infrared comands from either the receiver to the transmitter, to provide
source control from the display; or, from transmitter to receiver to provide display control from a
centrally located control processor.
The MS-070RI is supplied with a single 5V IR transmitter that can be connected to either of the
3.5mm jack sockets on the transmitter or receiver to the labelled ‘IR’ port. The 5V IR Receiver is
then connected to the 3.5mm jack socket labelled ‘IR’ on the opposite end of the link.
Please use the supplied MSolutions IR equipment within this kit - alternative manufacturers IR
cabling may not have the same pin configuration which, if used, could damage the componentry
inside the MSolutions extender, or the IR cabling.
Note: the 3.5mm jack sockets are bi-directional - it is only possible to send IR control in one
direction depending on which end of the link has the IR transmitter or receiver. It is not possible to
send IR controls in two directions simultaneously.
RS-232 Control
The MS-070RI can distribute bi-directional serial commands between the transmitter and receiver
to allow for control commands to be sent alongside the video and audio distribution.
Each HDBaseT unit is fitted with a 3-pin phoenix connector block that will need the serial TX, RX
and Ground pins terminating into. HDBaseT has the ability to transparently send any type of serial
data as both pieces of equipment are able to communicate using the same baud rate, stop-gap,
and parity.