M-E ODYON pro WE20/230, Инструкция по эксплуатации

Страница: 22 / 28

COMMISSIONING AND OPERATION
The wall receivers ODYON pro WE20/230 and WE40/230 are operated with 230V
mains voltage and may only be installed by a qualified electrician .
Communication between handheld transmitter and wall receiver
If the wall receiver receives a signal from a remote-controlled hand-held transmit-
ter, the switching contact is switched according to its setting and the receiver
sends a feedback signal to the hand-held transmitter, whose control LED indic-
ates this by flashing red/green.
Connection of operating voltage
Make sure that all connection lines are voltage-free and connect the connection
line to the connection terminal, L to the screw terminal "L", N to the screw ter-
minal "N" and, if present, PE to the screw terminal "PE". Then connect the unit to
be switched.
Connecting the units to be switched
Fig. 2 shows two examples of how a device to be switched can be connected to
the "Output" connection terminal. These are potential-free change-over contacts,
i.e. as long as the relay is not switched (orange LED of the corresponding channel
is not lit), the screw terminals COM and NC are connected. If the relay is switched
(orange LED of the corresponding channel lights up), COM and NO are connected.
Each contact may be loaded with max. 5A at 230VAC.
NC= Normally Closed (contact closed when relay is not switched)
NO= Normally Open (contact open when relay is not switched)
COM = Common contact
Input connection
At the "Input" connection terminal (9) you have the option of connecting e.g. 2
push-buttons in order to use the wall receiver like a 2-channel hand-held trans-
mitter. For this purpose, a potential-free contact (e.g. a simple push-button) can
be connected to the two screw terminals "IN1". Another push-button can be con-
nected to the screw terminals "IN2".
EN
22