M Design ZINO 1100, Инструкция по установке и эксплуатации

Страница: 6 / 13

The combustion pipe might be of black respectively stainless steel pipes and elbows. The flue
connection must be made by the shortest route to the flue by STN 73 4210. The combustion pipe
should be implemented and consolidate in order it cannot be released accidentally or spontane-
ously. All fluing should comply with the requirements laid down in Building Regulations Section J.
Connection of the combustion pipe of the Appliance type series „ZINO“can only be to the chimney,
which has been expertly tested. Based on expert examination of the appliance flue connection and
issue a professionally qualified person „Certificated examination on implementation of the chim-
ney, where a professionally qualified person to report state of the chimney and flue for their safe
and reliable operation.
2.4 LOCATION THE FIREPLACE FURNACE TYPE SERIES „ZINO“ON THE
FLOOR
In front of the door, inflammable floors need to be protected by placing the stove on a non combu-
stible material( Stone Glass, Marble, Ceramic Tiles Etc). The hearth needs to project at least 30cm
in front of the door and 30 cm at the sides and back if against a dry lined wall, however if the walls
are constructed of non combustible material ie Brick or stone then a minimum distance of 5cm
should be allowed.
2.4.1 REQUIREMENTS FOR PASSING COMBUSTION AIR
The fireplace furnace type series „ZINO“can be placed directly in the heated respectively outside
the heated space. Every form of combustion uses air. The combustion of fuel uses air from the
area where is the fireplace type series „ZINO“. In case of insufficient ventilation of this area is ne-
cessary to ensure sufficient fresh air from outside the duct can be connected to the inlet throat of
air. ( see Pic.6 )
Pic. 6
6