M Design ZINO 1100, Инструкция по установке и эксплуатации

Страница: 4 / 13

CAUTION:
It is not necessary to overload the fireplace with wood. 1kg dried wood gives a 4kW power.
Example: a fireplace with 80% return gives a power for about 3,2kW for 1kg dry wood. If
you want a power about 6-7kW, it is just enough to put 2kg wood in the fireplace. This is
like two normal pieces of wood. We are not responsible for the bad use of fireplace and any
consequence for not following this guideline. External surfaces of the stove are very hot
during operation, which has to be paid due attention to avoid an accident or burns.
2 INSTALLATION
2.1 ACTIONS TO BE TAKEN UPON INSTALLATION
For your own safety and satisfaction, we advise you to entrust a specialist with the installation.
The appliance has to be installed according to certain prescribes rules and local regulations.
The device must be built in an area with an adequate strength/capacity on the floor boards, which can
spread the weight of the stove. The stove must be positioned so as to maintain the safety distances
from any flammable materials. However, if you decide to carry out the work on your own, we advise
you to do the following:
• Refer to the terms and conditions of our contract of guarantee.
• Ask your supplier for advice.
2.2 LIST OF STANDARDS TO BE OBSERVED DURING ASSEMBLY AND OPERATIONS
The fireplace type „ZINO“complies with STN EN 13229. For installation and operation of the fireplace
type „ZINO“should proceed in accordance with STN 92 0300 „Local fire safety appliances and heat
sources” and STN 73 4201 „The design of chimneys and flues“.
4
Opening door
Opening handle
Pic.2
Pic.3