M Design Luna Diamond 1000CL, Инструкция по установке и эксплуатации

Страница: 15 / 44

15
Instructions for installation and use DIAMOND Gas DH-CL-CR-DC
7. Convenction current
It is MANDATORY to equip the fireplace with a convection kit consisting of inlets and
outlets which are connected to stretchable hoses from 3m to 5m.
In this way is created a circualtion and evacuation of the heat by convection.
This is very important to avoid overheating in the firebox casing and also to distribute
the air hot air in the room or in another adjacent room (office, kitchen, ...)
This system directs the heat inside the room using hoses (150mm dia.). It is neces-
sary to open minimum 2 hot air outlets. For the installation of these ducts, limit their
lengths, avoid as much as possible elbows and changes of direction, because the
losses of speed generated, decrease the efficiency of the air outlets at the end of
travel. We advise you to install the hot air grilles at the same height to have the same
heat provided. M-Design has developed hot air and ambient air outlet grilles available
from your dealer (see page 16).
Outlet grids have two or four hose connections (2/4 hoses on 1 grid!).
The air inlet grilles (not to be connected with a hose) must be placed as low as
possible at the bottom of the fireplace.
Please, follow this instructions. The appliance can overheat if you not apply
those instructions. Errorcode F02 will appear!
ATTENTION : A house is never completely 100 % dustfree, heating applian-
ces and warmth circulation create dust particles. During the periods where
you are not using the fireplace, dust is accumulated in the flexible pipe and
and the grills
This could cause a problem with a smell, so we would certainly advise you
to clear the flexible and air inlets and outlets using a vacuum cleaner regu-
larly. The smell caused by these dust particles will disappear after you have
used the fireplace again a few times. (This phenomenon is very common
and can be compared to the gray traces appearing above your radiators.)
Optionally you can order design metal lids to cover the inlets and outlets
during the summertime .