M Design Luna Diamond 1000CL, Инструкция по установке и эксплуатации

Страница: 13 / 44

13
Instructions for installation and use DIAMOND Gas DH-CL-CR-DC
Picture 4: ROOF EXIT WITH BEND
Appliance Ø 150/100 Ø 150/100
en/ et
Ø 200/130 Ø 200/130
1000 / 1150 / 1300 / 1600 /
1900 DH / CL / CR / DC
for each 90° bend subtract 1m
horizontally or add 1m vertically
1000 / 1150 / 1300 / 1600 /
1900 DH / CL / CR / DC
for each 45°/30°/15° bend subtract 0,5m
horizontally or add 0,5 m vertically
Ø 150/100 Ø 150/100
With reduction usvk13 on appliance
Appliance A (min) B (max) C (min) (A+B+C )max
1000 DH / CL / CR / DC 1,25* m A+C B-A-1m 17m
1150 DH 1,25* m A+C B-A-1m 16m
1300 DH / CL / CR / DC 1,25* m A+C B-A-0,5m 15m
1600 DH / CL / CR / DC 1,25* m A+C-1m B-A 14m
1900 DH 1,25* m A+C-1m B-A 14m
Ø 200/130 Ø 200/130
Without reduction
Appliance A (min) B (max) C (min) (A+B+C )max
1000 DH / CL / CR / DC 1 m (A+C) + 7m B-A-10m 19m
1150 DH 1 m (A+C) + 6m B-A-9m 18m
1300 DH / CL / CR / DC 1 m (A+C) + 5m B-A-8m 17m
1600 DH / CL / CR / DC 1 m (A+C) + 2m B-A-5m 17m
1900 DH 1 m (A+C) + 2m B-A-5m 17m
Caution: if the vertical part is 3 m
longer than the horizontal part, you must
use the restriction ring Ø75
5. Flame adjustment settings
Before initial setup, you need to clean the window (from outside and inside) and fire-
place of any dust and grease. If you do not clean the glass properly, after lightning up
the fireplace it can
remained still on the glass. After installing the fireplace correctly on the concentric
tube or chimney system, you must make a flame adjustment according to the draft
(see chapter 4 page9. Installing the c use restriction rings).
The air intake for flame can be adjusted in fireplaces. Setting element is situated on
the left side of the bottom plate in the combustion chamber. Adjustment of air intake
may only be set out by a specialist.