MM-007024-001
36
9.4.2.2 CH-103PA
Control Head CAN Termination
Connect the plug (male) connector of the CAN Y-cable to the rear of the CH-103PA and connect the
CAN Terminator (Item 3 in Table 4-3) to one leg of the Y-cable. See Figure 9-3. See Table 4-4 for CAN
Y-cable part numbers.
Figure 9-3: CH-103PA CAN Y-Cable and Common Microphone Interface Connections
9.4.3
Connect Control Head to Radio Via CAN Cable
1.
Route the CAN Cable (Item 4 in Table 4-3) through the vehicle’s channeling to the radio. Remove
interior panels, door kick panels, etc., as necessary. Protect the cable from possible chafing as
necessary.
2.
Attach the CAN Cable’s connector to one of the two CAN port connectors on the radio’s I/O cable.
3.
CH-103 Control Head:
Connect the other end of the CAN Cable to the open CAN port connector at
the rear of the Control Head.
CH-103PA Control Head:
Connect the other end of the CAN Cable to the open leg of the CAN
Y-cable.
4.
Loop, tie and stow the excess cable as necessary.
9.5 CONTROL HEAD POWER CABLE INSTALLATION
Plan the cable’s route carefully. For the red wire, ensure a route that will not crush or damage the wire in
any way.