8
«click»
«click»
7
75.0036.02 LZR-FLATSCAN 3D SW 20210215
Page 9 of 16
If desired and in addition to ANSI 156.10, 156.19, and 156.38 Knowing Act requirement, you can
add a Virtual Push Button option (max. 2 per sensor) within the second (C2) curtain simulating the
performance of a knowing-act device.
The Virtual Push Button(s) may be placed outside of the detection field but within a limit of maximum
detection field range specifications. To operate, the two gray wires of the FLATSCAN 3D SW must
be connected (as the primary sensor) to the activation on the door controller with the 10-wire cable
provided.
1. When the green LED flashes, hold your hand in the desired position within C2 to learn the Virtual
Push Button.
2. When the LED flashes red to confirm the teach-in, remove yourself and hand.
3. When the LED flashes green again, you can either learn another Virtual Push Button or wait 10
seconds for the end of the teach-in.
VIRTUAL PUSH BUTTONS (OUTPUT 3)
Close the cover starting on the narrow
side. Do not hesitate to push.
To remove the cover, position a flathead screwdriver in the notch
and pull upward until the cover loosens.
OR
FINAL STEPS
CLOSING
OPENING
Always verify compliance with ANSI 156.10, 156.19, and 156.38.
