|
SEDONA BY LYNX™ VENT HOOD CARE & USE/INSTALLATION
8
SECURING THE HOOD
MOUNTING HOLES:
Because the Sedona by Lynx™ Vent Hood was designed for all applications, no mounting holes have been pre-drilled.
This allows for custom applications for mounting. The hood should be attached to the framing through the top and back,
whenever possible. Remove the filters. Mark and drill screw holes through the hood as required. Secure the hood by
driving screws (provided by others) through the screw holes.
**NOTE: DRILLING THROUGH STAINLESS STEEL REQUIRES TITANIUM DRILL BITS. BE CAREFUL NOT TO DRILL
THROUGH THE UL LABEL OR INTO THE HOOD’S ELECTRICAL COMPONENTS
CARE AND USE
OPERATING CONTROLS:
Always activate the ventilator when using cooking appliances. Activate the ventilator a few minutes before starting to
cook to establish an airflow pattern within the room. Adjust the fan speed as needed. Adjust the dimmable halogen
lights as desired.
WARNING
ENERGY SAVING TIPS:
CARE AND CLEANING:
Do NOT operate the blower / ventilator system without the filters in place, or with dirty, grease laden
filters.
Do not operate the blower at a speed higher than necessary to remove the cooking exhaust. Turn off the unit once the
smoke and cooking odors have been eliminated. Clean filters and grease laden surfaces often to improve efficiency.
Proper cleaning is necessary to maintain performance and appearance, while also ensuring safe operation. The frequency
of cleaning should be adjusted according to the type and amount of cooking. Best results will be achieved by cleaning
soiled components as soon as possible. Filters must be cleaned regularly. Using the aluminum knob, lightly pull the filter
toward the front of the liner while pulling the backside downwards. Replacing the filter is just as easy as taking it out.
The filters may be cleaned by hand washing in hot water using a mild detergent solution, or by placing them in a dish-
washer. Locate holes on the sides of the filter. Put filter in dishwasher with holes facing up so detergent can enter filters.
Dry the filters completely before using again. Rinse and dry with a soft lint-free cloth. Always wipe stainless steel surfaces
with the grain. Never wipe across the grain. After cleaning, reinstall the filters carefully.
>> Most common scrubber type pads will scratch the hood, do not use them to clean the hood.
35320 Sedona Vent Hood Care and Use 2017.indd 8
2/16/2018 4:00:19 PM
