Lynx L54TRF-LP, Руководство по эксплуатации и установке

Страница: 16 / 44

16 |
INSTALLATION / USE & CARE
The grill arrives nearly ready to use and requires only minor
assembly.
By carefully following the uncrating and unpacking steps,
you will improve your fi rst experience with the grill.
Shipping weight on smaller units is app. 300 pounds and
larger units may weigh over 500 pounds.
CRATE & CARTON
• IMPORTANT! Do not remove staples around the top of the
carton. These staples hold a wooden pallet in place inside
the carton that protects the unit from damage. Removing
these staples may cause the pallet to fall on the top of grill.
How to Remove the Carton
• Cut the main strap holding the grill to the pallet.
• Remove the staples at the bottom of the carton.
• Lift off the carton.
• With assistance, remove the grill from the pallet and place
into desired location.
The wheels sit down in the gaps of the shipping crate so
that the grill can sit safely and solidly on the crate during
shipping. The grill cannot be slid directly off of the pallet.
One way to safely move
the grill off of the pallet is
by lifting one end of the
grill high enough to place
a ramp under the wheel
and then lift the other end
while rolling the grill off of
the pallet.
When pushing, lifting, or pulling a freestanding grill across
gravel, grass, pavers, brick, stone imprefections in the
surface, or wood slatted decks be cautious and move slowly
or use a carpet dolly.
Failure to do so may damage the structure of the cart
wyhich will not be covered under warranty.
INTERIOR PACKING
Lynx uses sturdy tie-down cables and straps to ensure your
grill arrives at your home in the same condition that it left our
factory. BE SURE YOU HAVE REMOVED ALL TIE DOWNS
BEFORE USING YOUR GRILL.
• Remove the white accessory box and wood packing, the
grill racks, and remove any loose items from the fi rebox.
• Carefully cut the cable ties securing the warming rack and
rotisserie spit (if equipped).
• Cut the strapping that secures the briquette trays and
carefully lift them out, front fi rst.
Make sure you remember to remove the tie-downs on the
burners.
• On Trident™ models, cut and remove ties from the burner
partition on the left side of the Trident™ burner.
• Ensure that all burners are properly seated on the burner
valve orifi ce and sitting level with the legs in the frame
slots and no side-to-side movement.
UNPACKING & ASSEMBLY
Use two or more people to move or install this unit.
Failure to follow this instruction can result in back
or other personal injuries.
WARNING:
EXCESSIVE WEIGHT HAZARD!
M
bu
•
•