- 15 -
Menu system
The Main Display on the front panel of the TDA 2200 is the users feedback of all
functionality and current status of the TDA 2200. When the amplifier is powered up the
Main screen shows the current Software revision in the Startup picture as:
Lyngdorf TDA2200
Version : 1.0
After showing the initial screen which can be used for identification of software revision the
main screen is showed (depending on standard settings)
Lyngdorf TDA2200
Preset: 1 Fs=96 kHz
Furthermore the Volume Control is set according to the standard settings which can be
altered in the menu system
In the display the Current Preset is shown and the detected samplerate of the input. If a
digital input is active the source samplerate is detected and displayed, if the Analog option
is mounted and selected the ADC samplerate 96 kHz will be displayed
Pressing the Menu button on the remote or the front panel enters the Menu system at top
level
Main Menu TDA2200
< Comm Adress >
With the Left/right keys the Menu system can now be scrolled through all settings until a
sub menu setting is accessed with a press on the Enter button. The Sub menus accessible
in version 1.0 are:
•
Comm
Adress
•
Comm
Speed
•
Trigger
Setup
•
Remote
Control
•
Display
Timeout
•
Def.
Volume
•
Max
Volume
•
Preset
•
AD
Sensitivity
The above menu points will be described in detail in the following:
Comm Current: 1
Adress New : 3
Comm Adress setting is the TDA 2200’s identity to the PC interface or other Lyngdorf
products. In master mode the amplifier setting is normally 1, and the addresses 2-99 can
be used for individual slave amplifiers, but nothing is restricted. In the menu the current
address and the new address is shown, The Up/Down keys can be used for changing the
new setting, and a new selection is stored with Enter which also exits the menu again. A
press at Menu again exits the menu without changing the current settings. The PC
software must know the address of the TDA 2200 in order to communicate with it.