24
DAILY MAINTENANCE
REPLACEMENT OF THE SQUEEGEE RUBBER
Figure 45
If the squeegee rubber is worn and does not dry well, it is possible to
change the drying edge proceeding as follows:
1.
Push and rotate the fixing plates
2.
Slip off the rubber blade and the rubber itself
3.
Turn the rubber upside-down and if necessary, replace it
4.
Adjust the squeegee height as indicated in “ADJUSTMENT HEIGHT
SQUEEGEE SUPPORT” under “MACHINE PREPARATION”
5.
Reassemble everything in reverse to the above mentioned operations
REMOVAL OF BRUSHES; MAGNA 85/100
Figure 46
1. Connect the battery connector if it is not connected
2. Turn the key into position ON
3. With the manipulator lift the brushes base
4. Turn the key into position OFF and remove it from the instrument
board (to carry out the operations of brush disassembly with
connected current can cause injury)
2
1
3
4
Figure 47
5.
With the brushes base in lifted position, rotate the brush until it comes
off from the brush plate seat as shown in the figure. The figure shows
the rotating direction for the disassembly of the right brush, the left
one has to be rotated inversely.
