17
PERFORMANCE
Figure 26
Magna 85/100
13.
Push forward the brushes manipulator (1) in order to lower the base. During the
descent, the signal lamps of the actuator and the brushes motor come on. The
brushes base will be in its working position when the yellow signal lamp (2)
switches off.
Magna 85S/100S
14. Push forward the brushes manipulator (3) in order to lower the base. During the
descent, the signal lamps of the actuator and the brushes motor come on. The
brushes base will be in its working position when the yellow signal lamp (4)
switches off.
4
3
1
2
Figure 27
15. Press the accelerator pedal. The machine begins to move, the squeegee begins to
lower itself and the suction motor comes on.
During the first few metres of operating, check that the brush pressure is suitable
(see further on under “BRUSH PRESSURE”), that the quantity of detergent solution
is sufficient and that the squeegee dries perfectly.
The machine will now start to work efficiently until the detergent solution runs
out.
Figure 28
Immediately disconnect the emergency lever (1) situated on the left side from the
operator and apply the emergency brake (2), whenever problems occur during
work.
These commands disconnect all the functions on the machine. To start the
machine again, once the problem has been solved, turn off the key (3), reconnect the
connector (1), switch on the key (3) and lower the parking brake lever (2).
Figure 29
The machine will not start if the operator is not properly seated.
When the solution tank is empty, the signal lamp on the instrument board comes on.
When the recovery tank is full, the suction motor stops. To start it up again, even if
the tank has been emptied, it is necessary to first turn off the main switch key and
then on again.
