English
- 46 -
Note
: Remove the batteries from the remote control
handset when it is not to be used for a long period.
Otherwise it can be damaged due to any leakage of
batteries. Remote range is approximately 7m/23ft.
Switching On/Off
To Switch the TV On
Connect the power cord to the 110-240V AC, 50
•
/60Hz.
Press STANDBY touch button. Then the standby
•
LCD lights up.
To switch on the TV from standby mode either:
•
Press the “
•
” button,
CH
/ CH
or a numeric
button on the remote control.
Press the control switch right side of the TV. The TV
•
will then switch on.
Note: If you switch on your TV via
P+
or
P-
buttons on
the remote control or on the TV set, the programme
that you were watching last will be reselected.
By either method the TV will switch on.
To Switch the TV Off
Press the “
•
” button on the remote control or hold
the control switch on the Tv until shut down , so the
TV will switch to standby mode.
To power down the TV completely, unplug the power
•
cord from the mains socket.
Note: When the TV is switched to standby mode, the
standby LCD can blink to indicate that features such
as Standby Search, Over Air Download or Timer is
active.
Input Selection
Once you have connected external systems to
your TV, you can switch to different input sources.
Press “
SOURCE
” button on your remote control
consecutively for directly changing sources.
Connecting to a DVD Player
If you want to connect a DVD player to your TV, you
can use the connectors of the TV set. DVD players
may have different connectors. Please refer to your
DVD player’s instruction book for additional information.
Power off both the TV and the device before making
any connections.
Note
: Cables shown in the illustration are not
supplied.
If your DVD player has an
•
HDMI
socket, you can
connect via
HDMI
. When you connect to a DVD player
as illustrated below, switch to the HDMI source. See
“Input Selection” section.
Some DVD players are connected through
•
COMPONENT SOCKETS (YPbPr). YPbPr can be
used only when you connect a device that has a
YPbPr output through the PC input with YPbPr to
PC cable (YPbPr cable is not supplied).
You may also connect through the SCART sockets.
•
Use a SCART cable as shown below.
Video Connection
HDMI
inputs
Scart socket
DVD player
YPbPr to PC
cable (optional)
Note:
These three methods of connection perform the
same function but in different levels of quality. It is not
necessary to connect by all three methods.
Remote Control Handset
Inserting Batteries
Remove the battery cover located on the back of
•
the handset by gently pulling backwards from the
indicated part.
Insert two
•
AAA/R3
or equivalent type batteries
inside. Observe the correct polarity (+/-) when
inserting batteries and replace the battery cover.
(Optional)
02_MB62_[GB]_(01-TV)_woypbpr_DVBT_C_PVR_NICKEL17_1910UK_32911W_10078118_50214306.indd 46
02_MB62_[GB]_(01-TV)_woypbpr_DVBT_C_PVR_NICKEL17_1910UK_32911W_10078118_50214306.indd 46
26.03.2012 14:24:05
26.03.2012 14:24:05