Product Name:
Resin Hollow Tree Outdoor Fountain
SKU #:
WHF991
Contact: [email protected]
Instruction Manual
Please save this manual for future reference.
WARNINGS:
1.
To reduce the risk of electric shock, connect only to a properly grounded, grounding type receptacle.
2.
To reduce the risk of electric shock, use only on portable self-contained fountains no larger than 5 feet in
any dimension.
3.
Do not exceed the voltage shown on the pump.
4.
Always disconnect the pump from the power source prior to beginning any maintenance or work on the
pump or fountain.
5.
Inspect the power cord for damage before installation and/or maintenance. Replace the entire pump if
damage is found.
6.
For pumps with a 3-prong, grounded type plug, do not remove the grounding pin from the plug on the
power cord.
PUMP ASSEMBLY INSTRUCTIONS:
Remove the pump from the package and untie the power cord.
1.
Place the pump in the desired location in your pond or fountain ensuring that it is completely submerged in
the water. If the pump is to be used in a pond, raise the pump off of the pond floor to ensure that it is
above any dirt that will collect, as this will adversely affect the performance of the pump.
2.
Adjust the flow rate (if applicable) to the maximum (+) position.
3.
Connect the power cord from the pump to a properly grounded, grounding type receptacle (GFCI).
4.
If necessary, readjust the flow rate to the desired level (remember to always disconnect from the power
source before handling the pump).
CARE & MAINTENANCE:
1.
Keep the water clean – clean water will prolong the useful life of your pump.
2.
Use a pre-filter on your pump if available.
3.
Regular cleaning of the pump will be necessary depending upon the environment in which it is operated.
Clean the pump when it is visibly soiled or when a noticeable drop in performance is detected.
Failure to
clean the pump will result in overheating of the pump and the voiding of the warranty!
4.
Before cleaning, always disconnect the pump from the power source.
5.
Disassemble the pump by removing the inlet screen & the impeller housing. Remove the impeller/rotor
assembly by gently pulling on the impeller blades. Use a soft cloth or brush to clean the area inside of the
pump where the impeller/rotor assembly was. Clean the inlet screen, impeller housing & impeller in warm
soapy water. Reassemble the pump and inspect for proper operation.
