Lutz 0001-115, Перевод оригинальной инструкции

Страница: 15 / 20

15
0698-301 Motor B1+B2 Battery - 01/20
en
5. Operation
3
For safe operation of the pump, sufficient space and a safe stand must be available.
NOTICE
Do not force the speed controller, otherwise it may be damaged. Then the motor will no longer work
properly.
!
WARNING
Danger of injury on the fingers due to free running drive shaft!
Before disconnecting or connecting the pump tube, necessarily switch off the motor and remove the battery.
► To start the motor, press the on/off switch ( → Fig. 7). After a long break, press the On/Off switch twice
to exit sleep mode. During failure-free operation, the on/off switch lights up continuously.
► The flow rate can be increased (clockwise) or decreased (counterclockwise) by turning the speed con -
troller ( → Fig. 7).
►
To turn off the motor, press the on/off switch again. The speed controller does not have to be turned
back. The motor starts at the last set speed.
► Remove the battery after each use of the motor and place it on the battery charger.
Sleep mode
►
After 2 minutes downtime, the motor switches to sleep mode. Then the first actuation of the on/off
switch causes the change back to the operating mode. Press the on/off switch again to start the motor.
Battery discharged
► The on/off switch starts to flash when the battery is discharged. This condition cannot be stopped The
battery must then be charged with the battery charger (
→
Operating instructions battery charger).
Overload
► The motor automatically switches-off when overloaded. The on/off switch starts to flash. The error must
be acknowledged by pressing the on/off switch again. If necessary, reduce motor speed. If the overload
persists, check the cause
→
Troubleshooting.
Disconnect pump tube from motor:
► Switch off the motor and wait until the engine stops turning.
► Remove battery.
►
Open quick fastener (
→
Fig. 3).
► Disconnect pump tube from motor.