Lutz 0001-115, Перевод оригинальной инструкции

Страница: 14 / 20

14
0698-301 Motor B1+B2 Battery - 01/20
en
► Do not immerse the pump tube in the liquid deeper than the outrun piece.
►
Fasten motor and pump tube in a way that the container cannot fall over.
► To start the motor, press the on/off switch ( → Fig. 7). After a long break, press the On/Off switch twice
to exit sleep mode. During failure-free operation, the on/off switch lights up continuously.
► The flow rate can be increased (clockwise) or decreased (counterclockwise) by turning the speed con -
troller ( → Fig. 7).
Fig. 7: On/off switch and speed controller
!
WARNING
Danger of injury on the fingers due to free running drive shaft!
• Never operate the motor without pump tube. Before opening the quick fastener, switch off the motor
and remove battery. Wait until the motor stops turning and then remove it from the pump tube.
• Always check that the motor is properly mounted on the pump tube before switching on the motor.
Speed controller
On/off switch