52
53
Wilma
Wilma
Deut
sc
h
Engli
sh
Troubleshooting
10
Miscellaneous
Problem
The light does not come on
and the power LEDs do not
flash when the battery is
plugged into the lamp.
With the battery plugged in,
the power LEDs do not come
on, but the PCS LEDs flash.
The Power LEDs do not stay on
for as long as they should.
Even after charging only
the 20% LED will light up
at the Smartcore battery.
Cause
Extremely discharged battery.
Battery not plugged into the
light or not plugged in
properly.
Faulty LED unit.
Discharged battery.
Old battery.
Very low ambient
temperature.
Faulty charger.
Unsuitable battery.
The indicator was reseted.
Solution
Charge the battery. Before
doing so be SURE to read
the “Battery cannot be
charged” section below.
Check all plug contacts.
Replace the LED unit.
Charge battery.
Replace battery.
Keep battery warm.
Replace charger.
Use original Lupine battery.
Discharge the battery with
your light and fully charge it
afterwards.
The laws governing the allowable application domain for this lighting system may vary from
one country to another. We recommend that you inform yourself about the relevant laws in
this domain in your country.
Regulations:
The mounting technique, as well as the design of Wilma lamps and the Power Control
System (PCS) are protected by European and US patents.
The product's two year warranty applies to all components, as well as any manufacturing defect.
The warranty does not include the battery, however. In addition, any modification or improper
use of the product will void the warranty.
Rights for improvements and modifications of our products reserved.
Changes:
Warranty:
The lamp does not recognize
the transmitter.
Lamphead and transmitter
are not linked.
See chapter operation
remote control.
The transmitter does not light up
while pressing the button and the
lamp does not react.
Button cell empty or
wrong side up.
See chapter operation
remote control.
