40
41
Wilma
Wilma
Deut
sc
h
Engli
sh
For establishing a connection, the receiving mode in the lamp has to be activated.
Keep the lamp’s button depressed until five
green LEDs
light up and let the
button go. The receiving mode is now active for 30 seconds. During this time, press the
remote control’s button until the remote does light up
green
.
release the button
Several lamps and one transmitter:
It is possible to connect up to five lampheads to a single remote switch.
Several transmitters and one lamp:
Up to 4 transmitters may be connected to one lamp. The transmitter-specific codes are
stored in the lamp according to a “first in first out” principle. If you want to use only one
transmitter again to control your lamp, it might be necessary to connect this transmitter
up to 4 times with the lamp until all other codes in the list will have been overwritten.
By default, your lamp has already been connected to the transmitter.
Connecting the transmitter to the light:
Enable/Disable the remotes permanent LED light:
Keep the remote button depressed: The LEDs must turn green then blue
again.
release the button
Low battery warning from lamphead:
The remote mirrors the lamphead's low battery warning.
A fully charged or partly discharged battery will be shown by a red LED light.
Details see page 38.
There will be no warning if the remotes button cell itself is empty.
Low button cell:
With decreasing voltage, the remotes LEDs will also become weaker, to
the point the remote does not work anymore. Also cold temperature does
reduce the battery voltage.
Transmitter battery change:
For changing the battery, loosen all 4 screws at the bottom
of the transmitter using a T5 torx screw driver.
Insert the new CR 2032 button cell as shown and close
the transmitter again.
Tighten the screws until the blue sealing is visibly squeezed.
T5 torx screw driver: (Art.No. 137)
3
3
