Lupine sl f nano classic, Руководство пользователя

Страница: 8 / 11

Assembly
As shown in the picture down below, the wire remote should be mounted right
next to the handle. Then attach the screw with the enclosed allen key size 2.
The remote lights green
 Low beam is activated.
The remote doesn‘t light

The lamp is switched off or
daytime running light is activated.
The remote lights blue

High beam is activated.
Wired remote
Turn on:
1. Activate the light at the display.
2. Turn it on by pushing the button of the wire remote.
Operation
After turning it on, the lamp lights either with daytime running light or low
beam (depending on the ambient light). If daytime running light is acti-
vated, you can switch to low beam and high beam by pushing the button
once.
Keep the button
pressed (let go to
select) until lamp
lights up
Available
settings
ECO mode
Reset to factory settings
(High beam: 14W, Low beam: 8W, Daytime running light: 2W)
High beam: 8W
Low beam: 5W
Daytime running light: 2W
Lights up 1x
Lights up 2x
Light sensor:
The light sensor is positioned behind the lens and meassures the ambient
light in a 5 sec. frequency as long as daytime running light is activated.
This can be perceived visually. When it‘s dark enough, the light switches to
low beam automatically.
Note: There‘s no sensor controlled switch from low beam to daytime
running light.
Turn off:
Keep button pressed for about 2 sec.
Operation