Lupine Betty TL2, Руководство пользователя

Страница: 17 / 19

32 33 Betty TL2 Betty TL2
Deut
sc
h
Engli
sh
Product care and storage
7 8
Troubleshooting
Problem:
The light does not come on and
the button's LEDs do not flash
when the flashlight head is
connected to the battery.
The power LEDs do not come on,
the button's LEDs flash when the
flashlight head is connected to
the battery.
The battery life is too short.
Cause:
 Deep discharged battery.
 Battery not or not properly
connected to the light head.
Faulty LED unit.

Faulty LED unit.

Discharged battery.

Old battery.

Very low temperatures.
 Faulty charger.
Solution:
 Charge the battery.
 Properly screw on the flash
light head.

Replace the LED unit.

Charge the battery.

Replace the battery.

Keep the battery warm.
 Replace the charger.
Check to ensure that the o-ring on the rear of the housing is correctly positioned. The
housing will only be waterproof if its o-ring is intact. After completing this check, carefully
screw down the housing cover. Important! The thread must always run smoothly, other-
wise, screw off the cover again immediately and try again. The fine thread will not excuse
any mishandling - therefore, be extremely careful! Fully screw down the cover.
Cleaning:
Only clean the lamp when it is fully assembled. If required, use warm water and add some
mild dishwashing detergent.
Transport:
Caution! Always separate the battery from the lamp!
Otherwise, the small amount of power used by the electronics will discharge the battery.
Furthermore, the lamp may be switched on accidentally. The uncontrolled heat buildup
could cause a fire or melt adjacent plastic material.
Storage:
When the lamp will not be used for a longer period of time, fully charge the battery and
leave it connected to the charger. Choose a cool, dry place for storage (basement etc.).
Note! The lamp housing may be opened for installing an upgrade kit or a lens.
Open the lamp housing's front screw-on cover. Hold the rear of the lamp with one hand
while rotating the front cover to the left (counterclockwise) with the other hand.
Once you have removed the cover, you will see the 7-array lens.
Please avoid touching the lenses directly.
Opening the lamp housing:
Closing the lamp housing: