In a view of the "sinking" described above, it is possible that the threaded rods touch the ground or the
foundations and could damage the roof when pushed upwards. Then simply saw a piece off the end with a
metal saw, so that they do not rest on the ground any more.
(please note that the drawing is not showing exactly the model Lillevilla
80).
At very windy and stormy building places special care must be taken when fixing the cabin to the
foundation and when fixing the roof construction to the cabin. This might require some extra hardware, which
are not included in delivery.
Diagram 7
Note!
This has to be considered already when the
foundations are prepared.
Threaded rod
Threaded rod
Washer and nut
Washer and nut
Wall supports
8.
The wall supports shall be mounted to the front and rear walls. They are ment to give extra support for the long
walls of the cabin. There are three slits and one pre-drilled hole in each wall support. Screw the metal plates
(can be found from the accessories bag, see
) on the slits (2 screws/plate and 3 plates/support). Fit
the supports to the front and rear walls as shown in diagram. The lower end of the support may reach the floor
inside the cabin. Drill 13 mm holes through the wall boards in the top third of the slit on the support and fix
using enclosed bolts, washers and nuts . It is important not to tighten the nuts too firmly, to allow the structure
room to "settle". Fix the wall supports down firmly using remaining bolts and nuts.
diagram 7b
You can then cover the
wall supports with the help of the covering boards and nails.
12
7b
Bolt
Washer
Metal plate
Metal plate
Washer
Nut
Wall support
Wall support
Wall timber
Drill 13 mm
Metal plate
16x57mm
16x57mm
16x57mm
16x145mm
16x145mm
Covering boards
Nail 45 mm
Lillevilla 80
300109