15
product. To do so, insert the card into its slot (11-c), turn your monocular
on and through the menu find and select “Format”, then select “OK”.
Once the card is formatted inside the device it is now ready to use.
USING DEVICE AS A RIFLESCOPE:
IMPORTANT:
Your monocular can function as a riflescope. Prior to using the scope on the
weapon, please remember the following:
1.
This item was designed for use on the following calibers only:
o
Airsoft guns
o
BB and Pellet guns
o
Most rimfire caliber weapons (.17WMR; .22LR; .22WSM and other
rimfire cartridges)
o
Centerfire calibers limited to .223REM; 5.45x39 (AK74 round) and
similar with total recoil energy of 4.5 or lower.DO NOT USE THIS
DEVICE WITH ANY CALIBER WITH RECOIL ENERGY OF OVER 4.5
2.
Know and observe all Federal, State and Local laws, regulations and
restrictions concerning possession and use of daylight and/or night vision
riflescopes. Luna Optics Inc cannot be held liable for unlawful and/or unauthorized
possession or use of this device.
ACTIVATING RETICLE / CHOOSING RETICLE TYPE AND ITS COLOR
Your device ships from the factory with default mode where aiming mark (reticle)
is not visible. To activate the reticle go to the main menu and scroll until “Reticle”
and then short-press the Super Controller to enter this menu chapter. You will see
the factory default reticle. Now you can rotate the Super Controller in either
direction to select the type of reticle (there are 5 types available). Once you select
the preferred reticle type short-press Super Controller and you will exit the menu.
The selected reticle will now be visible on the screen.
Once the reticle is activated you may now select its color. There are 7 colors
available. Once selected the color you like simply short-press the Super Controller
and you will exit the menu and the reticle will be displayed in selected color.
ATTACHING DEVICE TO THE WEAPON
Your monocular can be attached to any standard Picatinny Rail via the included
weapon mount (10). NOTE: mount design may be slightly different from the one
pictured, as updates are constantly made to improve its function.
First, attach the mount to
the bottom of the
monocular, using the 3
screws (12) as shown on
picture here. If you plan to
use the device as a
12
13
10
