Page 1 of 2
Teava
- Installation Instructions
REV0.6 02142019
*LUMINII RESERVES THE RIGHTS TO CHANGE SPECIFICATION & INSTRUCTION WITHOUT NOTICE
Model:
TEA-
7777 Merrimac Ave
Niles, IL 60714
T 224.333.6033
F 224.757.7557
[email protected]
www.luminii.com
E472444
Please read all instructions prior to installation and keep for future reference!
1. PRODUCT TO BE INSTALLED BY A QUALIFIED
ELECTRICIAN.
2. USE ONLY WITH CLASS 2 POWER UNIT.
3. 24 VOLTS DC.
4. SUITABLE FOR DAMP LOCATIONS.
5. MORE THAN ONE PERSON IS RECOMMENDED FOR THIS
INSTALLATION.
1.1
After removing the fixture from the packaging. Slightly pullon the plenum wire through the fixture arm to remove any slack.
1.2
Align the fixture arm endcap to the fixture head, make sure to rotate to the desired position. Then secure by tightening the set screw using the
provided Allen wrench
1.3
Repeat for the remaining arm(s). Depending on the fixture type, it may come with additional arms for joiner.
3
3.1
Align and then tap each anchor onto the marks until the
threaded section. Followed by tightening the anchors with a
Phillips screw driver. (Anchors not provided)
wall
3.1
anchor
wall
mark
anchor
3.1
3.1
fixture head
fixture arm
plenum wire
1
fixture arm
fixture head
set screw
1.1
Allen
wrench
1.2
single fixture
extended fixture
2.1
Measure the distance from one mounting bracket to the next. Then mark these location to the wall. Use the reference detail of mounting bracket
above, for any additional information.
support arm
(over 72” models)
joiner arm
(over 116” models)
fixture
arm
measure
mounting
bracket
2
2.1
measure
measure
measure
1.2”
1.1”
Ø2.0”
Ø0.35
Ø0.17
2.1
4.1
Secure each mounting bracket onto the anchors using the
appropriate hardware.
4
screw
mounting
bracket
anchor
4.1
