REV1.0 June 19, 2020 2:47 PM
KILO Channel
- Installation Instructions
Page 2 of 3
*LUMINII RESERVES THE RIGHTS TO CHANGE SPECIFICATION & INSTRUCTION WITHOUT NOTICE
7777 N. Merrimac Ave
Niles, IL 60714
T 224.333.6033
F 224.757.7557
[email protected]
www.luminii.com
Please read complete instruction prior to installation and keep for future reference!
1. Product should be installed by a qualified electrician.
2. Prior to installation ensure power is off at fuse box to prevent electrical shock.
3. If extrusion is installed facing up and in a wet location, ensure proper drainage and silicone endcaps and diffuser lens.
6
6.1
mounting br
ack
ets
ever
y 20”
extrusion
6.1
Mounting bracket must be installed every 20”, secure using the provided screw. Snap the extrusion into the mounting brackets.
6.2
To remove the extrusion from the mounting brackets, carefully insert a flat screwdriver to the bottom edge of the extrusion then pull up until the extrusion pops up.
screw
7.1
Snap the lens into the extrusion to secure in place.
7.2
If extrusion going to be installed outside, add silicone to the endcaps & the full length of the lens. To help avoid getting water inside the extrusion, but will not make waterproof.
7
7.1
diffuser
lens
end cap
If shortening LineLED, cut down in between the two rows of solder pads. Always cut
LineLED from the end without connector/wire leads. Ensure that LineLED strip/s fit
completely
inside the extrusion and the solder pads do not touch the metal endcaps
to avoid shorting of circuit.
4
wire
leads
solder
pads
LineLED strip
Ensure aluminum extrusion is
clean from dust before taping
the LineLED strip/s. If necessary
wipe extrusion and let dry before
installing.
Install the LineLED strip/s as close
as possible to extrusion ends to
avoid dark spots.
5
feed LineLED
wire leads
through one of
drilled holes
remove LineLED
paperbacking
from adhesive
tape before
installing into
extrusion
MB-KILOC-SS
Stainles steel screw-in
mounting bracket
7.2
