*LUMINII RESERVES THE RIGHTS TO CHANGE SPECIFICATION & INSTRUCTION WITHOUT NOTICE
Page 2 of 2
7777 Merrimac Ave
Niles, IL 60714
T 224.333.6033
F 224.757.7557
[email protected]
www.luminii.com
7.1
Remove the protective film from the diffuser lens. Snap the diffuser lens into
the aluminum extrusion.
7.2
If extrusion is to be installed facing up in wet locations, apply silicone to
the edges of the endcaps. Followed by applying silicone to the edge
between the lens and extrusion, make sure to clean off any excess
silicone.
7
endcap
protective film
7.1
7.2
7.2
silicone
dispenser
KM, KS, KXL & KL Channel -
Installation Instructions
Please read all instructions prior to installation and keep for future reference!
1. Product to be installed by a qualied electrician.
2. Prior to installation ensure power is off at fuse box to prevent electrical shock.
Models KMC-XX, KSC-XX, KXLC-XX, & KLC-XX
REV0.2 09062018
5
5.1
Extrusion are not waterproof. If it is going to be installed
Optional:
facing up and in a wet location, drainage holes should be drilled
along the inner corner of the extrusion every 12". Drill 1/16" to 1/8"
diameters holes before installing LED strip.
12.00"
corner drainage hole
corner
drainage
hole
5.1
solder pads
4.1
LineLED can be shortened by cutting along the dashed lines in between
the solder pads. Make sure the cut is made on the side of the LineLED
without the wire leads. LineLED cannot touch the metal endcap which will
shorten the circuit.
cut
LineLED
cut
4.1
wire leads
LineLED
4
3.1
extrusion
6
6.1
Prior to installing LineLED to extrusion, clean extrusion from any debris.
Gently push LineLED onto aluminum extrusion and then install endcaps at
both ends.
endcap
feed LineLED wire leads
through the endcap opening
remove paper backing on the
adhesive tape of the LineLED
before installing to the extrusion
8.1
Ensure the correct (wattage & voltage) power supply is used to power
LineLED. Then proceed to connect LineLED wires from extrusion to power
supply. For more information please refer to power supply and LineLED
wiring instructions.
8
line voltage wires
low voltage wires
class II power
supply
LineLED of
extrusion
8.1
6.1
