Page 2
For technical questions, please call 1-888-866-5797.
Item 56521
WARNING SYMBOLS AND DEFINITIONS
This is the safety alert symbol. It is used to alert you to potential
personal injury hazards. Obey all safety messages that
follow this symbol to avoid possible injury or death.
Indicates a hazardous situation which, if not avoided,
will result in death or serious injury.
Indicates a hazardous situation which, if not avoided,
could result in death or serious injury.
Indicates a hazardous situation which, if not avoided,
could result in minor or moderate injury.
Addresses practices not related to personal injury.
READ ALL INSTRUCTIONS
IMPORTANT RETAIN FOR FUTURE USE: READ CAREFULLY
WARNING:
Basic safety precautions should always be followed to reduce the risk of fire, electric shock
and personal injury. Install in accordance with these instructions and current electrical codes such as the
National Electric Code (NEC). This product has not been evaluated under section 590 of the NEC.
When used outdoors in wet conditions, ground fault circuit interrupter protection (GFCI) is to be
provided on the circuits or outlets. Extension cords used must be a type rated for outdoor use,
such as the following: SEW, SEOW, SEOOW, SOW, SOOW, STW, STOW, SJEW, SJEOW,
SJEOOW, SJW, SJOW, SJOOW, SJTW, SJTOW, or SJTOOW. The connector cover should
always be in place to prevent the entry of water (unless a string light connector is inserted).
POWER SUPPLY
CAUTION: Risk of electric shock.
Avoid making connections or disconnections when the equipment is
wet. Do not use with extension cord near water or where water may accumulate. Do not submerse
.
CAUTION
- To reduce the risk of fire, electric shock or injury to persons:
1. String Lights are intended for
installation indoors or outdoors.
2. String Lights must be supported by steel guide
cables or other suitable supporting hardware
such as S-hooks, screw hooks or zip ties (not
included) whenever span distances exceed
24 feet (7.3m). See Installation on page 4.
3. Lights should be installed so that
bulbs are facing down ONLY.
4. Do NOT secure light string to buildings
or other structural supports using nails,
staples, or other sharp, conducting materials.
DO NOT DAMAGE THE WIRE.
5. Avoid damage to the insulation during installation.
Do NOT pierce or compromise wire’s or
socket’s outer covering, jacket or sheathing.
6. Periodically inspect wire and sockets for
degradation due to weather, UV light or other
damage. Promptly replace light string.
7.
WARNING:
- RISK OF ELECTRIC SHOCK!!
Disconnect power supply at source prior to wring,
replacing light bulbs or servicing in any way.
8. Do not link more than 6 string lights together.
9. Keep proper footing and balance at
all times during installation.
10. Verify that installation surface has no hidden
utility lines before drilling, driving screws.
11. Maintain labels and nameplates on the String Light.
These carry important safety information.
If unreadable or missing, contact
Harbor Freight Tools for a replacement.
12. Remote Control contains Li-Ion button cell
battery. Risk of fire and burns. Do not
recharge, disassemble, heat or incinerate
battery. Keep battery out of reach of children.
Dispose of used batteries properly.
