Page 3
For technical questions, please call 1-888-866-5797.
Item 56521
13. The warnings, precautions, and instructions
discussed in this instruction manual cannot
cover all possible conditions and situations
that may occur. It must be understood by the
operator that common sense and caution are
factors which cannot be built into this product,
but must be supplied by the operator.
SAVE THESE
INSTRUCTIONS.
Specifications
Controller Input
120 VAC / 60Hz
Controller Output
5 VDC
Single LED Wattage
0.8W
Single String Wattage
15W
Maximum number of String Lights
that can be connected together
6
Remote Control Battery
Li-Ion CR2025
Suitable for wet location use.
Installing/Replacing LED Bulbs
Read the ENTIRE IMPORTANT SAFETY INSTRUCTIONS section at the beginning of this manual
including all text under subheadings therein before set up or use of this product.
Procedures not specifically explained in this manual
must be performed only by a qualified technician.
TO PREVENT SERIOUS INJURY: Unplug the String Light from its electrical
outlet before performing any procedure in this section.
Do not replace LED bulbs during rain or when wet.
1. Carefully remove existing lens by turning
it counter clockwise. It should be tight to
keep moisture out
. Put lens aside.
2. Remove LED bulb by pulling on its
LED stem. Discard old bulb.
3. Insert a new LED bulb by aligning its side
guide to the grooves inside the socket. Gently
push it in until flush with the socket.
4. Replace saved lens by carefully
screwing it on clockwise until tight.
Socket
Gasket
LED Blub
LED Stem
Lens
