Full product range & more information:
www.lumenalights.com
INSTALLATION
(continued)
:
WALL MOUNTING
Required: 2 x M10 * 60mm Expansion Screws
1.
Ensure the 4 x bottom screws on the fitting are tightened
with the allen key provided.
2.
Drill the 2 x 14mm holes at a depth of 60mm (104mm
centre to centre).
3.
Insert expansion screws into the wall and fasten to the
fitting securely.
4.
Optional Tilt
–
loosen the 2 x screws on both sides of
the lamp to adjust the lamp angle. Adjust up to 20
degrees upwards and 10 degrees downwards. Re-tighten
screws when positioned at desired angle.
IMPORTANT:
Standard bracket must be mounted the correct way up to enable 20 degree tilt upwards and 10 degree tilt
downwards. Side, pre-drilled holes are located slightly closer to the lower edge of the bracket. If bracket is ever removed fully,
ensure it is re-attached as per the above explanation.
HIWAY MAX TECHNOLOGY:
The Hiway MAX is a highly efficient solar light with high capacity LiFePO4 batteries and a fast charging Monocrystalline solar
panel. This means that even on cloudy and rainy days, it will re-charge efficiently. The high battery capacity gives enough power
for up to 6 nights. The 4800 lumen light output is impressively bright, powerful enough to illuminate car parks, driveways and
paths, making them safe to navigate at night.
In particularly long periods of dull weather, illumination time is likely to be affected. To boost charge, turn the light off for 1-2
nights which will result in the light charging but not illuminating. Then turn the light back on as normal. It is recommended that
Mode B (Motion Sensor Mode) is used at times when weather is poor to help retain charge.
See overleaf for Modes & Settings
Page 3 of 4
