Lumberjack TS254SW, Инструкция по безопасности и эксплуатации

Страница: 21 / 34

TS254SW 19
MAINTENANCE AND SERVICE
Maintenance and Service
Maintenance and Cleaning
Before any work on the Table Saw itself, pull
the mains plug.
If the machine should fail despite the care taken
in manufacturing and testing procedures, repair
should be carried out by an approve service
centre.
– Store the tool, instruction manual and
accessories in a secure place. In this way you will
always have all the information and parts on
hand.
Changing the saw blade
WARNING: Always unplug the saw from the
power source before maintenance to avoid risk
of serious personal injury.
To remove the blade:
1. Remove the blade guard and the blade throat
plate
2. Raise the blade to the highest possible
position.
3. To keep the arbor from rotating, place the
spanners on the flange flats.
4. Place the wrench on the arbor nut.
5. Turn the wrench clockwise to tighten,
counterclockwise to loosen. Loosen and remove
the arbor nut.
6. Remove the flange and pull the blade off the
motor shaft.
To install the blade:
1. Install new blade onto motor shaft and
assemble flange.
2. Turn the wrench clockwise to tighten the arbor
nut.
3. Reassemble blade guard and the blade throat
plate.
IMPORTANT: Blade rotation is clockwise when
observing from the right side of the saw. Make
sure the rotation direction mark on blade matches
with that.
Cleaning
– For safe and proper working, always keep the
power to land its ventilation slots clean.
– Remove dust and chips after each working
procedure by blowing out with compressed air or
with a brush.