Lumberjack TS254SW, Инструкция по безопасности и эксплуатации

Страница: 16 / 34

TS254SW 14
OPERATION
Operation
On-Off switch
– Switch on = press green switch [1].
– Switch off = press red switch [0].
Blade elevation handle
The blade elevation handle (13) is used to raise
and lower the saw blade. Rotate blade elevation
handle clockwise to lower the blade and
counter-clockwise to raise it (See Fig. L)
Blade tilting wheel
The blade tilting wheel (15) is used to tilt the saw
blade for bevel cutting
The blade bevel adjustment lock (9) holds the
beveling mechanism in the desired position.
When setting the angle of the cut, loosen the
blade bevel scale. Set the blade at the desired
angle. Tighten the blade bevel adjustment lock
by turning it clockwise. Before turning the table
saw “ON”, be sure all adjustments are securely
tightened to prevent the blade from shifting
during operation.
The splitter
The splitter (14) separates the two pieces of wood
that result after the work-piece is pushed through
the saw blade. The splitter prevents binding and
kickback.
Rip fence
This rip fence is used for all ripping operations.
Never rip freehand without the fence in place and
securely locked.
Mitre gauge
The mitre gauge (5) is used for performing cross
cuts and mitre cuts and mitre cuts. The gauge
head is locked in the desired position by tightening
the locking handle (a). Always ensure the locking
handle is securely fastened before starting a cut.
To adjust the mitre gauge angle, loosen mitre
gauge locking handle and rotate the mitre gauge
body so that the “0” mark on the end of the sliding
bar points to desired position, then tighten the
locking handle. To adjust the mitre fence, loosen
the locking knob (b) and slide the mitre fence to
the desired position. Then tighten the locking
knob.
NOTE: The mitre gauge body has marks at 5-
degree increments. The sliding bar has marks at 1-
degree increments. Read both to get an accurate
angle degree.