Lumberjack TS254SW, Инструкция по безопасности и эксплуатации

Страница: 17 / 34

TS254SW 15
OPERATION
Push stick
The device used to feed the work-piece through
the saw during narrow ripping cuts. The push
stick helps to keep the operator’s hands well
away from the blade. Use the push stick for
ripping widths less than 6”(150mm) and more
than 2”(50mm).
Basic table saw operations
a. When crosscutting, mitre cutting, bevel cutting,
compound mitre cutting or rebating across the
end of a narrow work-piece, use the mitre gauge.
b. Never make these cuts freehand (not using the
mitre gauge or other devices)because the blade
could bind, causing a kickback or causing your
hand or fingers to contact the blade.
c. Always lock the angle of the mitre gauge when
in use.
d. Except for when making rip cuts, remove the rip
fence from the table.
e. Make sure the blade guard is mounted for all
through sawing operations(the blade cuts through
the entire thickness of the wood). Re-attach the
guard immediately after finishing dado, molding or
rebating cuts.
f. The blade should extend approximately 1/8”
(3mm) above the top of the work-piece.
g. Use the push stick whenever you make a narrow
cut.
Crosscutting
Crosscutting is cutting wood across the grain at
90
°
or square with both the edge and the flat side
of the wood. This is done with the mitre gauge set
at “0”. Before using the mitre gauge, make sure it
is locked. The mitre gauge can be used in either of
the grooves in the table.