Lumberjack DP20-1630F, Инструкция по безопасности и эксплуатации

Страница: 15 / 24

DP20-1630F 13
Removing the chuck
1. Align key holes in spindle and quill (A ) by rotating
the chuck (C) by hand.
2. Insert drift key (B) into key holes in the quill.
3.Tap key drift key lightly until the chuck and arbour
fall out of the spindle.
NOTE: Place one hand below the chuck to catch it
when it falls out.
Adjusting the table square to the head
1. Insert a precision round steel rod (A)
approximately 3” long into the chuck and tighten.
2. With the table (B) raised to working height and
locked into position, place a combination square (C)
flat on the table beside the rod .
3. If an adjustment is necessary, loosen the table
bevel lock bolt (D) with an adjustable wrench and
loosen the set screw (E) below the table bevel lock
bolt. These adjustments are located under the table.
4. Align the table square to the rod by tilting the
table.
5. Retighten the table bevel lock bolt. Retighten set
screw.
Tilting the table
To use the table in a bevel position, loosen the bevel
lock bolt (D) with an adjustable wrench. Tilt the table
to the desired angle by reading the bevel scale on the
table support. Retighten the bevel lock bolt.
Feeding
Pull down the feed handles (A) with only enough effort
to allow the drill to cut. Feeding too slowly might cause
the drill to burn...feeding too rapidly might stop the
motor...cause the belt or drill to slip... tear the
workpiece loose or break the drill bit.
Hole location
Make an indentation in the workpiece where you want
the to drill a hole using a centre punch or a sharp nail.
Before turning the switch ON, bring the drill bit down
to the workpiece, lining it up with the hole location.
ADJUSTMENTS