Lumberjack DP20-1630F, Инструкция по безопасности и эксплуатации

Страница: 11 / 24

DP20-1630F 09
8.While holding the rack (A) and table support
(B) in an engaged position, slide both down over
the column (C). Slide rack down the column until
the rack is positioned against the lower column
support (D).
9.Replace column collar (A) and position it bevel
side down over the rack (B). Tighten set screw
(C) in collar with 3mm hex. key (D). To let the
rack slide when the table is swung to the left or
right around the column, the collar must sit
loosely over the rack and should not be angled
on the column. Only tighten set screw enough to
keep the collar in place, otherwise the collar may
break due to excessive pressure.
NOTE: To avoid column or collar damage, do not
overtighten set screw.
10. Locate the support lock handle (A) in loose
parts bag and tighten by hand.
11. To minimize crank backlash; tighten the
support lock handle and rotate the elevation
worm shaft clockwise with the crank handle.
Loosen the set screw in the crank and reposition
it as close to the table support as possible.
Tighten set screw in the crank handle.
Installation the head
1. Remove the protective covering from the head
assembly.
2. Carefully lift the head above the column and
slide it down on the column as far as it will go.
Align the head with the table and the base.
3. Using a 4mm hex. Key, tighten the head set
screws on the right side of the head.
Installing pulley cover knob or locking
pulley cover
1.Install the knob (A) Fig.13B to the pulley cover
(B) using a small pan head screw (C) as shown in
Option #1.
2.For safety reasons, user may be required to lock
the pulley cover to prevent easy access to the
pulleys. This can be done by only using the small
pan head screw (C). Close the pulley cover and
screw panhead screw through the cover and into
the tab (D) as shown in Option #2.
ASSEMBLY INSTRUCTIONS